 |
|
Slip-On Installation
Because The GripMaster grips are engineered for simple slip-on installation, you can install our grips just like you would install any slip-on synthetic grip. Most golf shops will have all of the supplies and tools you will need - however, we recommend using Brampton HF-100 tape activator and our own grip tapes. Brampton is a water-based tape activator that simplifies the installation process and your grips are playable in as little as 15 minutes after installation. If you prefer solvent based installation, click here.
|
Supplies Needed
- Grip tape
- Bramption HF-100 Tape activator
- The Grip Master grips
Equipment Needed
- Vinyl shaft clamp
- Bench vise
- Sheetrock knife or carpet knife to remove old grip
- Straight-edged knife or heat gun to remove old tape
|
General Tips - PLEASE READ!
- Completely cover the grip area on the shaft with tape - do not leave gaps!
- Take care not to kink or bend the grip when installing. This can move the strapping or even tear the underlast. In most cases, if the underlast is not torn, the strapping can be re-tensioned if moved. (See re-tensioning.)
- Put on right-handed grips with a clockwise motion
- Counter rotate both ends of the grip to line up the cap and grip logos square with the club face
Interested in Tapeless Installation?
- Click HERE for discussion of tapeless installation
- Click HERE for tapeless installation blow-on tool
HF-100 Advance Grip Tape Activator
5 Step Easy Grip Process
| |
|
STEP 1
Apply any standard grip tape to shaft. Use enough tape to cover the length of the grip and extend the tape 1/4" over butt end of the shaft. |
| |
|
|
| |
|
STEP 2
Spray a small amount of HF-100 on the grip tape. |
| |
|
|
| |
|
STEP 3
Spray a small amount of HF-100 into the grip. |
| |
|
|
| |
|
STEP 4
Install the grip by pushing it over the taped end of the shaft. |
| |
|
|
| |
|
STEP 5
Wipe off excess HF-100 with a dry cloth. Carefully align the grip so the logo is squre with the club face. Grips are playable in as little as 15 minutes. |
|
Installation Accessories
The GripMaster recommends Brampton HF-100 for installation of your grips. Brampton is a safe, non-volitale water-parafin emulsion that lets anyone easily and professionally install grips. Click the link or image to see our installation products.
|
|
MSDS Product Sheet
HF-100 is a safe Parafin-Water Emulsion. Click the link above for complete safety information on this product.
|
|
|
